CA18DET Installation 7 - Cooling System
continued
Last Updated:
22/06/2008
|
| I got some S13 rad brackets from a wrecker, I needed to
open up the holes in them a bit to get a decent M8 bolt through them. |
  |
| Then select some washers/brackets to get the rad
brackets to the right height. |
   |
| Drill them in - to the rad support panel, they ended up
fairly close to the intercooler bolts, but not close enough to cause a
problem. |
   |
| Now the bottom mounts needed just a little tweaking to
get the height up a little - as the bottom hose was rubbing on the front
cross member. |
   |
| Finishing off those intercooler brackets, marked up
ready to drill |
   |
| Drilled the brackets |
    |
| Then drilled through the rad support and slipped in the
bolts |
    |
| Tighted the top intercooler and radiator brackets |
  |
| Shortened the upper rad hoes to suit - seems a 1200 is a
little smaller than a 180SX |
    |
| |
|
| |
|
| |
|
| |
|
| |
|
| |
|
